1998 Johnson Evinrude EC 50 thru 70 HP 3-Cylinder Service Manual, Page 217Get this manual
Driveshaft Shimming Using Tool, PIN
The driveshaft pinion is precisely meshed with the forward and reverse gears by using shim or shims between the driveshaft bearing housing and the thrust washerWhen installing new thrust bearing or washer, bearing housing, pinion or driveshaft, it is necessary to properly shim the assembly to restore factory clearanceGauge bars are precision made and should be handled carefullyThe length of each bar is stamped near the part numberThis dimensron is 0.020 in(0,508 mm) shorter than the actual shimmed length of the driveshaft
INote Degrease pinion and driveshaft tapers prior to assembly13s1 13s1
1Install the pinion onto the driveshaftTighten the pinion nut to 40-45 ftIbs(54-60 Nm)
2Assemble the driveshaft bearing housingthrust washerand thrust bearing onto the driveshaftUse OMC Driveshaft Seal Protector, PIN 312403, whenever installing or rery wving the bearing housingCOA3594