1998 Johnson Evinrude EC 5 thru 15 HP Four Stroke Service Manual, Page 291Get this manual
10Remove nut and pulley retainer from mandrel and remove starter assembly11Install spindle, screw, and locknutTighten locknut to 120-144 inIbs(14-16 Nm)
[] 12Install pawl, linkage, and retaining ring (sharp edge up)13Examine lockout partsReplace any worn or damaged parts
Installation
1Install starter assembly on motor with screwsTighten screws to 60-84 inIbs(7-9 Nm)Push cable into starter housing and shift detent with locking tabs on the sidesSecure with tie strap2Check operation of starter and starter lockoutStarter should crank motor when in NEUTRALStarter MUST NOT crank motor in FORWARD or REVERSE