1998 Johnson Evinrude EC 5 thru 15 HP Four Stroke Service Manual, Page 260Get this manual
Assembly
INote Make no dry assembliesLubricate
gear with OVIC Ultra-HPF gearcase lube
bearings, shafts, and
1Oil the small bearing and install it in the propeller shaft bearing housing using OVIC Bearing Installer, PI 339751Press against the lettered side of the bearing when installing2Oil the large bearing and install it in the propeller shaft bearing housing using OVIC Bearing Installer, PI 339751Press against the lettered side of the bearing when installing
rn 3.rear of the Seal Installer, PI Apply DPL Penetrating LubriUse OVIC 342663, to install new seal in the bearing housingcant to the casing of the seal before installingInstall the seal with the exposed lip facing away from the bearing housingPress the seal into the housing until the tool seatsApply OVIC Triple-Guard grease to the seal lips after installing 4Apply OVIC Triple-Guard grease to new bearing housing a-ringPlace the a-ring in the bearing housing groove