1998 Johnson Evinrude EC 5 thru 15 HP Four Stroke Service Manual, Page 235Get this manual
Installation
1Apply OMC Triple-Guard grease to the steering handle sleeve and install it in bracket
2Attach steering handle to the bracketTighten the nut just enough so the handle will maintain any position
rn 3blackOMC Pin Insert3-pin Amphenol pluginstall the stop Use Tool, PI 322697, to button wire into the rn 4Position the stop ground wire behind thetoport sideinIbsof the ignition module and install the screwTorque 48-96
(5,4-10,8 Nm)5Thread anchor onto cable housing until anchor is 1Js in(3 mm) from aft end of housing threadsInstall screw and washer to retain the throttle cable anchorTorque to 48-96 inIbs(5,4-10,8 Nm)