1998 Johnson Evinrude "EC" 25, 35 HP 3-Cylinder Outboards Service Manual, Page 265Get this manual
v DRC6245 DRC6246
Trim Gauge Troubleshooting
rn 1Turn key switch ONUsing"G"voltmeter, check for voltage between the trim gauge "I" and terminals If no voltage, check condition of instrument harness, key switch, and engine 20-amp fuse
If voltage, go to Step 2
2Remove the whitetan lead from the trim gauge "S" terminalWith key switch ON, gauge should indicate full-trim DOWN positionNow connect jumper wire between the white tan lead and the trim gauge "G" terminalGauge should indicate full-trim UP position If your results are different, replace the trim gauge If your results agree, refer to Trim Sender Troubleshoot-