1998 Johnson Evinrude "EC" 25, 35 HP 3-Cylinder Outboards Service Manual, Page 194Get this manual
Assembly
INote Make no dry assemblies
Lubricate bearings, shafts, and gears with 0IVk: Ultra-HPF gearcase lube
rn 1Oil and0IVk: Bearing Installer, PIinN aft end ofPress bearing install new bearing the housing using 335820against
the lettered side of the bearing to prevent damage to the bearing when installingPress the bearing into the housing until the tool is seated on the housing
rn 2Oil and install a0IVk: Bearing Installer,forward end of the new bearing in the bearing housing using PI 321428Press
against the lettered side of the bearing until the tool is seated on the bearing housing3Install new seals back to back in aft end of the bearing housing using 0IVk: Seal Installer, PI 335821 Apply 0IVk: Gasket Sealing Compound to the metal casing of the seals before installingInstall the inner seal with lip facing into the bearing housing and install the outer seal with lip facing away from the bearing housingApply 0IVk: Triple-Guard grease to the seal lips after installing