1998 Johnson Evinrude "EC" 25, 35 HP 3-Cylinder Outboards Service Manual, Page 192Get this manual
15Use OMC Bearing Puller, PI 432130, attached to OMC Slide Hammer, PIN 432128, to remove the forward bearing cupSecure the puller jaws into grooves behind the cup with jaws facing port and starboardUse OMC Wrench, PIN 334359to hold the puller while tightening the jaws
[] 16Use OMC Puller Bridge, PI 432127, and OMC Small Puller, PI 432131, to remove the driveshaft seals from the gearcase
INotellnspect bearings in placeIf bearing is removed for any reason, it must be replaced[] 17Remove the upper driveshaft bearing and bearing sleeve from the gearcase using the same two toolsDiscard the bearing
18To remove the pinion bearings, assemble the following components from OMC Universal Pinion Bearing Remover and Installer, PI 391257:
PIN 326582 Rod PIN 326583 Pilot Plate PI 326577 Remover and Installer -20 12 inHex Head Screw -20 inHex Head Screw CD in0.0Flat Washer