1998 Johnson Evinrude "EC" 25, 35 HP 3-Cylinder Outboards Service Manual, Page 145Get this manual
OJ 7Connect the low oil light lead to the engine harnessSecure the connector to the ignition module 8Install the starboard lower motor cover W W
9Attach the steering arm to the tiller armSecure with two screws and washersTighten the screws to 216-240 inIbs(24-27 Nm)Thread two locknuts onto the threaded ends to the two tiller arm screws and tighten to 216-240 inIbs(24-27 Nm)10Place the shift and electrical cables in the lower motor cover grommet and secure in place in the lower motor cover11Apply OMC Locquic Primer to the two trunnion anchor screws and allow to air dryApply OMC Nut Lock adhesive to the screwsAttach the trunnion anchor block to the crankcase and secure with the two screws Tighten the screws to 84-106 inIbs(9-12 Nm) 12Attach the throttle cable ball socket to the throttle lever using OMC Ball Socket Installer, PI 342225Attach the shift cable to the shift lever and secure with clip 39249