1998 Johnson Evinrude "EC" 25, 35 HP 3-Cylinder Outboards Service Manual, Page 143Get this manual
49Remove the backing from new intake manifold gasket and install it in place on the reed box side ofthe manifoldRefer to the Fuel System section and install the leaf plate assemblies
rn 50.and allow to air dryApply OMC Ultraeight intake manifold Apply OMC Locquic Primer to the screws Lock adhesive to the
screwsInstall the intake manifold and secure with the screwsTighten the screws to 60-84 inIbs(7-9 Nm)
rn 51.with twothe throttlespark shoulder to theTighten the bolt Install lever crankcase and secure flat washers and boltto 60-84 inIbs(7-9 Nm)
INote The larger of the two flat washers must be placed between
the throttlespark lever and the crankcase52Apply OMC Triple-Guard grease to the inside and outside of the two throttle lever bushings Install the bushings into the bosses on the crankcase53Apply OMC Triple-Guard grease to the throttle lever shaft