1998 Johnson Evinrude "EC" 25, 35 HP 3-Cylinder Outboards Service Manual, Page 137Get this manual
1 [] 4Lubricate new driveshaft a-ring and lightly lubricate crankshaft splines with OMC Moly LubeInstall a-ring in sleeve
rn ringUsing sharp edge facing ring pliers, install bearing retain5external retaining with away from bearinging
6Lubricate the two center main bearings and split sleeves with outboard lubricant and install them in their original positionsThe split sleeve ring grooves must face away from flywheel when installed
rnsealInstall the crankshaft seal ringsMake sure the ends of 7the rings overlap properlyrn 8Lightly lower OMC Gasket Sealing Compound on the of the apply metal case of new housing sealPosition the exposed lip
seal into the lower housingPress against outer metal case of the seal until the edge of the metal case is flush with the inside surface of the lower housing