1998 Johnson Evinrude "EC" 25, 35 HP 3-Cylinder Outboards Service Manual, Page 126Get this manual
[] 7Tiller Electric Models: Remove the two screws securing the electrical connector cover to the engineRemove the cover[] 8Disconnect the stop switch wire connector Remove the stop switch wire from the ground stud]9Tiller Electric Models: Disconnect the 6-pin connector]10Tiller Electric Models: Remove the two neutral start switch wires (yellowred) from the connectorMake sure to identify the pin locations (2 and 6) for installation during reassembly [IQ]
11Remove the throttle cable ball socket from the ball on the throttle lever using OMC Ball Socket Remover, PI 342226Remove the clip securing shift rod CD to shift leverRemove shift rod from lever12Remove the two screws Q) securing the trunnion anchor block to the engine