1998 Johnson Evinrude "EC" 25, 35 HP 3-Cylinder Outboards Service Manual, Page 112Get this manual
Ohmmeter TestStop Button
INote All ohmmeter tests must be performed with the engine NOT running
rn 1The steering handle contains combination stop buttonemergency stop device When the clip and lanyard assembly is removed, the emergency stop device is in the STOP position When the clip and lanyard assembly is installedthe emergency stop device is in the RUN position To stop the engine when the clip and lanyard assembly is in place, press the stop button until the engine stops
2Install the clip and lanyard3Calibrate an ohmmeter on appropriate scaleDisconnect 4-pin Amphenol connector between stop button and ignition moduleConnect meter leads between stop button terminal "B", and clean engine ground The meter must show high reading4Momentarily, press inward on the stop button The meter must show low reading 5Remove the clip and lanyard The meter must show low reading