1998 Johnson Evinrude "EC" 25, 35 HP 3-Cylinder Outboards Service Manual, Page 104Get this manual
Packard Connector Servicing Terminal Removal
A tab on the back side of the terminal engages shoulder in the connector's body to hold the terminal in place
1Pry seal out of connector2Slightly pull on wire to move tab
rn 3Insert tool, such as the one shown, connector above the terminal to push the tab downrn 4Push the tool and wire out of the connectorTerminal Installation
away from shoulderinto the
The terminal must be pulled into the connector to lock it in placeBefore installing new terminal on wire, insert the wire through the seal and connector[] 1The tab on the terminal must extend enough to lock the terminal in place inside the connectorIf the tab isn't extended, use thin tool and bend it outward slightly2Pull terminal into connector3Push seal into connector until seated