1998 Johnson Evinrude "EC" 25, 35 HP 3-Cylinder Outboards Service Manual, Page 102Get this manual
[] 9Remove screw retaining the ignition coil to powerheadRemove coil with spark plug wireInstallation
1Apply OMC Locquic Primer and OMC Nut Lock to the ignition coil mounting screwPlace ignition coil in position and torque screw to 84-106 in Ibs(9-12 Nm)
2Apply OMC Locquic Primer and OMC Nut Lock to three ignition module mounting screwsPlace ground wire Q) and lock washer under module mounting bossPosition the ignition module and torque screws to 84-106 in Ibs(9-12 Nm)Place ground wire and lock washer into position and secure with screw CD tightened to 84-106 inIbs(9-12 Nm)3Install tanblack no-oil sender lead into 2-pin Amphenol connector using OMC Insert Tool, PI 322697Connect 4-pin Amphenol connector to engine harness and secure on ignition module4Attach three primary wires to ignition coils: