1998 Johnson Evinrude "EC" 2 thru 8 Service Manual, P/N 520202, Page 205Get this manual
15 12Remove and discard both gearcase head sealsUse avIC Puller Bridge, PIN 432127, and avIC Small Puller, PI 432131
13Remove and discard the gearcase head bearingUse
avIC Bearing Removerl lnstaller, PI 392091
14Remove and discard both driveshaft sealsUse avIC Puller Bridge, PI 432127, and avIC Small Puller, PI 432131
G!l15To remove the upper and lower driveshaft bearings, assemble the components of the avIC Driveshaft Bearing Remover and Installer, PIN 392092 (Guide PlateSmall Disc with flat side toward bearing, and Rod ), within the gearcaseAttach avIC Slide Hammer, PI 391008, to the rod and remove both bearings at the same time
16To remove the forward gearcase bearing, assemble avIC Puller Bridge, PIN 432127, and avIC Bearing Puller, PI 432130Make sure that the jaws of the puller are oriented vertically and then extract the forward bearing17To remove the shift rod bushing