1998 Johnson Evinrude "EC" 2 thru 8 Service Manual, P/N 520202, Page 166Get this manual
Assembly
INotel Proceed slowlyMake no forced assemblies unless a
pressing operation is called forAll internal components must be perfectly clean and lightly coated with Johnson or Evinrude Outboard Lubricant
INotel Use new gaskets, seals, and O-rings during assembly1If removed, install wrist pin bearing using OMC Bearing Installer and Remover, PIN 327645
1221 Note When installing wrist pin bearing, the oil hole must
align with the hole in rod end
12311241 2
Using OMC Cone, PIN 333142, and Driver, PIN 333141, install one snap ring in groove of pistonWhen installed, gap of the ring should be positioned opposite groove in the pistonTo avoid personal injury, use insulated gloves when handling pistons that have been heated400 (93204 C)Using OMC Piston Cradle, PIN 326573, and OMC Pressing Pin, PIN 333141, oil the wrist pin and start it into the piston opposite the installed retaining ringDo not allow the wrist pin to enter the piston cavity