1998 Johnson Evinrude "EC" 2 thru 8 Service Manual, P/N 520202, Page 154Get this manual
22Inspect wrist pin, needle bearings, and washersIf worn, replace all these components23Refer to Cleaning and Inspection at beginning of this section
Assembly
INote Proceed
slowlyMake no forced assemblies unless pressing operation is called forAll internal components must be perfectly clean and lightly coated with Johnson or Evinrude Outboard Lubricant
INotel Use new gaskets, seals, and O-rings during assembly
INotel Make sure water deflector
in place
1Apply coat of oil to wrist pin and wrist pin hole in piston