1998 Johnson Evinrude "EC" 125C, 130, 200, 225, 250 90 deg LV Service Manual, P/N 520212, Page 398Get this manual
Trim Sending Unit AdjustmentConventional It might be necessary to adjust the trim sending unit to coincide with the trim gauge at full trim-up positionTo do this, proceed as follows: 1Turn key switch to the ON position2Raise the engine with the tilt switch to maximum trim-up position
3V4Move the angle adjusting rod
to the center hole
4Loosen the sending unit screws sending unit can be pivoted
until only snug, so the
5V4Lower the engine all the way down against the angle adjusting rod