1998 Johnson Evinrude "EC" 125C, 130, 200, 225, 250 90 deg LV Service Manual, P/N 520212, Page 395Get this manual
Trim Sending Unit AdjustmentFasTrak 1Tilt the engine and engage the mooring bracket
2Temporarily, install PIN 387278 thrust rod in the No3
rn 3Loosen thebesending unit screws until only snug, so the pivoted sending unit can
4Disengage the mooring bracketLower the engine against the thrust rod
rn 5position ,the trim engine up the needle the sendingshow Observe gaugeIf does not center tilt the and adjust unit
by pivoting it up or down6Lower" the engine against the thrust rod to verify adjustmentRepeat Step 5, if necessary7After adjustment is correct, tilt the motor up, tighten the two sending unit screws, and remove the thrust rod