1998 Johnson Evinrude "EC" 125C, 130, 200, 225, 250 90 deg LV Service Manual, P/N 520212, Page 321Get this manual
Installation
1Place new O-ring on the driveshaftCoat the driveshaft splines with OMC Moly LubeDo not coat top surface of the driveshaft as lubricant here may prevent seating of the driveshaft in the crankshaft
2Apply OMC Adhesive sealant to the lower exhaust housing seal inner surfacesPosition two new seals on the housingApply OMC Triple-Guard grease to the seal outer surfaces and position the housing on the gearcase3Slide the gearcase into place making sure that the driveshaft
engages the crankshaft, the water tube enters the water pump, and the lower inner exhaust housing does not slip out of position