1998 Johnson Evinrude "EC" 125C, 130, 200, 225, 250 90 deg LV Service Manual, P/N 520212, Page 311Get this manual
7Install new seal in rear ofthe bearing housing using 0fVk: Seal Installer, PI 341439Apply DPL Penetrating Lubricant to casing of the seal before installingPlace back of seal against tool and install it until tool is seatedApply 0fVk: Triple-Guard grease to the seal lips after installing8Lightly apply OMC Triple-Guard grease to new bearing housing a-ringsInstall the a-rings and set the bearing housing retainers and screws aside
Driveshaft Bearing Housing Service
The driveshaft bearing is not serviceableReplace the bearing housing if the bearing is worn or damagedAlso, inspect the driveshaft bearing surface if the bearing is damaged[] 1Remove the driveshaft bearing housing seal using 0fVk: Puller Bridge, PI 432127, and 0fVk: Large Puller Jaws, PI 432129Discard the seal2Remove the a-ring from the bearing housing and discard it3Clean the bearing housing in solvent to remove sealer from the seal bore and the a-ring groove