1998 Johnson Evinrude "EC" 125C, 130, 200, 225, 250 90 deg LV Service Manual, P/N 520212, Page 302Get this manual
Installation 1Coat the driveshaft splines with OMC Moly LubeDo not coat top surface of the driveshaft as lubricant here may prevent seating of the driveshaft in the crankshaft2Apply OMC Adhesive sealant to the lower exhaust housing seal inner surfacesPosition two new seals on the housingApply OMC Triple-Guard grease to the seal's outer surfaces, and position the housing on the gearcase3Rotate the propeller shaft and shift the gearcase to FORWARD
4On relieved split-line exhaust housings, apply OMC Gel-Seal II to gearcase mating surface padsSlide the gearcase into place, making sure the driveshaft engages the crankshaft, the water tube enters the water pump, and the lower inner exhaust housing does not slip out of position