1998 Johnson Evinrude "EC" 125C, 130, 200, 225, 250 90 deg LV Service Manual, P/N 520212, Page 293Get this manual
7 DR5720
42297 14155
7Install new seal in rear of the bearing housing using OIVIC Seal Installer, PIN 341439Apply OIVIC DPL Penetrating Lubricant to casing of the seal before installingPlace back of seal against tool and install it until tool is seatedApply OIVIC Triple-Guard grease to the seal lips after installing
[] 8Lightly apply OIVIC Triple -Guard grease to new bearing housing a-ringsInstall a-rings in its grooves in the housingDriveshaft Bearing Housing Service The driveshaft bearing is not serviceableReplace the bearing housing if the bearing is worn or damagedAlso, inspect the driveshaft bearing surface if the bearing is damaged[] 1Remove the driveshaft bearing housing seal using OIVIC Puller Bridge, PI 432127, and OIVIC Large Puller Jaws, PIN 432129Discard the seal2Remove the a-ring from the bearing housing and discard it3Clean the bearing housing in solvent to remove sealer from the seal bore and the a-ring groove