1998 Johnson Evinrude "EC" 125C, 130, 200, 225, 250 90 deg LV Service Manual, P/N 520212, Page 261Get this manual
4Place the swivel bracket between the stern brackets and attach the tilt cylinder
5Install the tilt tubeInstall one thrust washer on each side of the swivel bracket as the tilt tube is pushed into place
6Install the locknutReplace locknut if definite resistance to tightening is not felt7V6, V8 ModelsInstall the second thrust rod and locknutReplace locknut if definite resistance to tightening is not felt8Torque all stern bracket fasteners!
Torque tilt tube nuts to 50-54 ftIbs(68-73 Nm) then loosen one nut by 1fs to 114 turn Torque screws, stern bracket to trim manifold, to 22-24 ftIbs(30-33 Nm) Torque thrust rod locknuts to 30-35 ftIbs(41-47 Nm)9V4 ModelsInstall the tilt angle adjustin rod