1998 Johnson Evinrude "EC" 125C, 130, 200, 225, 250 90 deg LV Service Manual, P/N 520212, Page 260Get this manual
rn 7If and remove the trim and tilt unit.stern required, remove the screws, manifold, Assembly
bracket to trim
V6, V8 ModelsRemove the second tilt cylinder thrust rod
Before proceeding, be sure all components have been thoroughly cleaned Replace any seals that have been removedInspect all thrust washers and bushings for evidence of deterioration
[] 1If removed, install an upper steering shaft bushing, lower seal and upper seal in the swivel bracketBoth seal lips face out Coat seal's outside diameter with OIVC Gasket Sealing Compound Coat the bushing and seal lips with OIVC Triple -Guard grease 2Install the trim and tilt unitApply OIVC Locquic Primer and OIVC Nut Lock to the threads of screws, stern bracket to trim manifoldInstall them loosely V6, V8 ModelsInstall the tilt cylinder thrust rodReplace the locknuts if definite resistance to tightening is not felt(7