1998 Johnson Evinrude "EC" 125C, 130, 200, 225, 250 90 deg LV Service Manual, P/N 520212, Page 114Get this manual
Installation 1Install new intake manifold gaskets dryUse no sealer2V6, vaUpper intake manifold must be installed firstEngage throttle cam, washer, and nut on manifold stud as you install manifold INotel
Recirculating fitting on upper intake manifold must be covered with OMC Protective Cap, PIN 322892, to prevent an air leak
[] 3Apply Permatex No.2 to threads of all intake manifold screws that protrude into the crankcase cavityTorque the manifold retaining screws to 60-84 inIbs(7-9 Nm) and torque the throttle cam nut to 144-168 inIbs(16-19 Nm)4Install new carburetor base gaskets, dryInstall the carburetorRefer to Carburetor Installation, this section5To accurately adjust all carburetor linkage, refer to Synchronization and Linkage Adjustments, Section 1system and check for leaks! Fuel leakage could contribute to fire or explosion