1998 Johnson Evinrude "EC" 125C, 130, 200, 225, 250 90 deg LV Service Manual, P/N 520212, Page 110Get this manual

1998 Johnson Evinrude "EC" 125C, 130, 200, 225, 250 90 deg LV Service Manual, P/N 520212, Page 110

11Install new O-ring seal, and attach main body to throttle bodyTorque mounting screws in "X" pattern to 45-55 inIbs(5-6 Nm)seal out of position
INote When positioning main body, be careful not to roll O-ring
Installation

1Install new carburetor base gaskets dry; use no sealer2Carefully, install fuel hosesRefer to Hose Routing Chart, this sectionSecure all hoses with tie straps
1251 12s1 1271

3Position carburetor and engage throttle shaft connector link{s)
4Install nuts and screws per carburetor, and tighten in an "X" pattern to 120-144 inIbs(14-16 Nm)

Back to 1998 Johnson Evinrude "EC" 125C, 130, 200, 225, 250 90 deg LV Service Manual, P/N 520212