1997 Johnsoon Evinrude "EU" 50 thru 70 3-Cylinder Service Manual, P/N 507266, Page 156Get this manual
Assembly
Proceed slowlyMake no forced assemblies unless pressing operation is called forAll internal components must be perfectly clean and lightly coated with Johnson or Evinrude Outboard Lubricant
INote Use new gaskets, seals, and O-rings during assemblyIT]
1Apply OMC Needle Bearing Grease to the 28 wrist pin bearingsInstall the bearings in the wrist pin boreAlign the bearing in the bore using CIVIC Wrist Pin Bearing Tool, PIN 336660
rn rn rn rn
2Place the two wrist pin thrust washers on the tool with flat side of the washers facing out3The connecting rod has no specific orientationSupport the piston in OMC Piston Cradle, PI 326573Oil the wrist pin bore and wrist pin 4Install the wrist pin through the piston and connecting rodpushing the tool out through the piston