1997 Johnsoon Evinrude "EU" 50 thru 70 3-Cylinder Service Manual, P/N 507266, Page 44Get this manual
Synchronization and Linkage Adjustments -
50TTl,60TTl,65RS
INote It is important that this step-by-step procedure be followed
in sequence and be performed exactly as written to ensure consistent engine idling and smooth operation throughout the RPM range
INote The flywheel
has two timing gridsFor TTL models, use the second timing grid (flywheel rotating in clockwise direction); 65RS, use the timing grid marked "Rope"Set Timing Pointer
INote Ifthe timing pointer or intake manifold has been disturbed,
check the top dead center timing pointer alignment&
1To prevent accidental starting of the engine while servicing, twist and remove all spark plug leads
2Center the timer pointer Rotate the flywheel in clockwise direction until the cast-in mark is approximately 1112 in(4 cm) past the timing pointer
rn andInstall in center portion PIN 384887, in No.1No.1 piston3OMC Piston Stop, spark plug hole turn until it contacts the
Lock the tool in place with ring
OJ 4While holding the flywheel firmly against the tool, mark