1997 Johnson Evinrude "EU" Accessories Service Manual, P/N 507270, Page 153Get this manual

1997 Johnson Evinrude "EU" Accessories Service Manual, P/N 507270, Page 153

Installation

1Lubricate the tilt cylinder with OMC Triple-Guard greaseSupport the power trim unit in position and insert the tilt cylinder pin2Install the electrical cable through the stern brackets

3Insert the spring clip to the tilt cylinder pin
4Install the six bracket to manifold screwsApply OMC Nut Lock to threads of the new screwsTighten the screws to torque of 18-20 ftIbs(24-27 Nm)53-Cylinder and V4Install the angle adjusting rod in same location as removed

6V8Install the thrust rodsTighten the nuts on the two thrust rods to torque of 30-35 ftIbs(41-47 Nm)7Tighten the tilt tube nuts to torque of 50-54 ftIbs(68-73 Nm), then back off one nut 14 turn

Back to 1997 Johnson Evinrude "EU" Accessories Service Manual, P/N 507270