1997 Johnson Evinrude "EU" Accessories Service Manual, P/N 507270, Page 152Get this manual
12511261
27Thread the end cap into the cylinderUsing torque wrench installed 900 to the special tool, tighten the end cap to torque of 18-21 ftIbs(24-28 Nm)Tighten band nut securelyDo not lay the tilt cylinder on its side because oil will leak out of the band nutPlace the two nylon bushings back in the large hole at the base of the tilt cylinderPosition the tilt cylinder in the manifoldInstall both upper and lower hydraulic lines, finger tightBe sure there is an O-ring on each end of the hydraulic lines Tighten the fittings on the ends of the hydraulic lines to torque of 14-18 ftIbs(19-24 Nm)pin
1271 1281
or thrust
28Position the manifold as shownInstall the tilt cylinder rod