1997 Johnson Evinrude "EU" Accessories Service Manual, P/N 507270, Page 108Get this manual
.41818 41791 41792
OJ 33-Cylinder, 60 and 90 V4, and 60 V6 -
Three of the four springs are one length, and the fourth spring is shorteran assembly, the shorter spring can be positioned in any hole in the pistonSet piston aside
rn cap.Using screwdriver, carefully and discard the largeof the 4pry the scraper out end Discard the scraperRemove outer
5Remove and discard inner a-ring of the end cap41795
Tilt Rod Reassembly
rn a-ring thethe end capLubricatethen lubricatenew scraper.a 1Clean end cap thoroughly, and install in and install new
The scraper is installed with the lip facing outThen lubricate and install new a-ring on the outside of the end cap[]] 2Use wire brush to clean all thread-locking material from the threads on the tilt rod[]] 3Lubricate the inside surface of the end capLubricate and install OMC Tilt Cylinder Seal Protector, PIN 326005 Use deep-well socket and plastic mallet to drive the end cap onto the rod, then remove the seal protectorSlide the end cap down the tilt rod