1997 Johnson Evinrude "EU" Accessories Service Manual, P/N 507270, Page 102Get this manual
Power TrimTilt Servicing Removal
1Separate the power trimtilt connector, and remove the rubber grommet
2Remove the terminals from the connector by using suitable tool to depress the tabWhile the tab is depressed, pull on the wire from the rear of the connector to release it from the connector
rn 3Remove clamp and disconnect 2-pin Amphenol connector[] 4Disconnect the two bullet connectors for the tilt limit switch[] 5Pull the wires through the hole in the port side of the lower engine cover