1997 Johnson Evinrude "EU" 90 thru 115 90 CV Service Manual, P/N 507267, Page 221Get this manual
Shift Rod AdjustmentTiller Models The shift cable must be adjusted correctly or water pressure from forward boat travel could move the gate into REVERSE, causing the boat to stop abruptlyOccupants could be thrown about or ejected In
1Pull up on shift cam until cam roller is at the far end of the FORWARD detent range 2Loosen connector nut CDMove shift handle to FORWARD positionThread connector Q) onto shift rod to align with hole in shift cam3Install connector pinSecure connector pin with washer and cotter pin
4Move shift handle to NEUTRALThe cam roller should snap into NEUTRAL detent when you pull up on the reverse gate with moderate pressure5If you cannot achieve NEUTRAL detent, remove connector pin, then rotate connector to lengthen shift rod slightlyRecheck your adjustment