1997 Johnson Evinrude "EU" 90 thru 115 90 CV Service Manual, P/N 507267, Page 196Get this manual
25V4Remove the water intake screen by depressing the tabs and pushing upward Inspect the screen for blockagePropeller Shaft Bearing Housing Service
rn OMCRemovePullerseal using OMC Puller Bridge, PIN 432127, 1the and Small Jaws, PIN 432131Position the plate on top
of the housing to support the bridge, and tighten the jaws securely behind the seal
1Note Inspect bearings in placeIf bearing is removed for any reasonit must be discarded[] 2Remove either bearing using OMC Puller Bridge, PI 432127, and OMC Large Puller Jaws, PI 432129Rest the puller plate on top of the housing to support the bridge, and tighten the jaws securely behind the bearing3Discard the bearing housing a-ring Clean the housing and bearings in solvent, and dry thoroughlyIf bearings were not replaced, rotate the needles with your fingers to check for freedom of movement4Inspect -ring groove, and sand off any sharp edges that would cut the a-ring and prevent its sealingCheck for and remove any nicks or burrs on front surface of bearing housingV4Thoroughly clean the threads of the four bearing housing retaining screwsDiscard the retaining screws' seals