1997 Johnson Evinrude "EU" 90 thru 115 90 CV Service Manual, P/N 507267, Page 186Get this manual
Propeller InstallationV4
1Avoid accidental starting of engine while changing propellers; twist and remove all spark plug leads
2Place engine's shift lever in NEUTRAL3Coat the propeller shaft splines sparingly with CIJIC TripeGuard grease
mIbsInstallNm)propeller nut and tighten propeller nut and 6the to torque of 120 (14 If cotter pin holes in the inpropeller shaft are not aligned, continue to tighten the nut until they are in lineDo not loosen
4Place the thrust bushing in the propeller, then slide the assembly onto the propeller shaft5Install the thrust washer on the propeller shaft splines
m 7.Bend itsaends over the nut to secure the propeller nut and Insert new cotter pin through the assemblyshaft8Make sure engine is in NEUTRAL; give propeller spinIt must turn freely
Water Pump ServicingV4, V6
If the gearcase has been in service for any length of time, it is good policy to install water pump repair kitTo install the repair kit, proceed as follows: Removal