1997 Johnson Evinrude "EU" 90, 105RW, 115, 150, 150W, 175 60 LV Service Manual, P/N 507268, Page 263Get this manual

1997 Johnson Evinrude "EU" 90, 105RW, 115, 150, 150W, 175 60 LV Service Manual, P/N 507268, Page 263

Installation
rn 1Apply

QVIC Adhesive sealant to lower exhaust housing seal inner surfacesPosition two new seals on housingApply QVIC Triple-Guard grease to seal outer surfaces and position housing on jet drive housing
2Slide jet housing into place, making sure driveshaft engages crankshaft, water tube enters water pump, and lower inner exhaust housing does not slip out of position
rnhousing Apply screws and rear Compound to threads of rn 3retaining Gasket Sealing exhaust housing screwjet

Install two 38 -16 2112 inscrews in forward holes CD and two 38 -16 inscrews in rear holes Q)Install rear spacer and screwTorque all screws to 18-20 ftIbs(24-27 Nm)

4Install key, bushing, shims, tab-washer, and nut on driveshaftBe sure shims are placed in original positionRefer to Impeller Clearance Adjustment5When proper clearance adjustment is achieved, torque impeller nut to 16-18 ftIbs(22-24 Nm)

Back to 1997 Johnson Evinrude "EU" 90, 105RW, 115, 150, 150W, 175 60 LV Service Manual, P/N 507268