1997 Johnson Evinrude "EU" 90, 105RW, 115, 150, 150W, 175 60 LV Service Manual, P/N 507268, Page 242Get this manual
1351 1361 1371
21Push the propeller shaft out of the bearing housing 22Remove the thrust bearing and thrust washer
23Remove both seals using QVIC Puller Bridge, PIN 432127, and QVIC Small Puller Jaws, PIN 432131Position plate on top of housing to support bridge and tighten jaws securely behind lower seal
13SliNoteilnspect bearings in placeIf bearing is removed for any reason, it must be discarded
24Remove either bearing using QVIC Puller Bridge, PIN 432127, and QVIC Large Puller Jaws, PIN 432129Rest puller plate on top of housing to support bridge and tighten jaws securely behind bearing25Clean housing and bearings in solvent and dry thoroughlyIf bearings were not replaced, rotate needles with your fingers to check for freedom of movement'Inspect O-ring groove and sand off any sharp edges that would cut O-ring and prevent its sealing