1997 Johnson Evinrude "EU" 90, 105RW, 115, 150, 150W, 175 60 LV Service Manual, P/N 507268, Page 237Get this manual
COA3558
[]] rn 8.The driveshaftthe pinion taper isremove it from the Pull up on driveshaft to gearcaseto locking taperIf
necessary, use CWIC Puller, PIN 390706 CD, and OIVIC Backing Plate, PIN 325867 Q), to break the lockInstall the tools as shown by clamping them around the driveshaftAlternately tighten the two vertical screws against the backing plate inserted between the puller and the gearcase until the driveshaft pops loose from the pinion, then remove the tools
m 9.washers will come out shimsthe driveshaftThe bearing housing(b), thrust bearing with thrust
[] 10Reach inside the gearcase and take out the pinion, nut, and any loose needle bearings that may have fallen into the gearcase11Push down on the shift rodThis will move the detent lever downward to clear the inside of the gearcase when the propeller shaft assembly is pulled out