1997 Johnson Evinrude "EU" 90, 105RW, 115, 150, 150W, 175 60 LV Service Manual, P/N 507268, Page 224Get this manual
12411251
24Inspect the water intake screen for blockageRemove the screen by using one of the following methods: Depress tabs and push up Remove two screwsone on either side, and remove
Propeller Shaft Bearing Housing Service
1Remove the seal(s) using OMC Puller Bridge, PIN 432127, and OMC Small Puller Jaws, PIN 432131Position the plate on top of the housing to support the bridge, and tighten the jaws securely behind the lower sealIf bearing is removed for any
1 1Inspect bearings in placeNote
reason, it must be discarded
2Remove either bearing using OMC Puller Bridge, PIN 432127, and OMC Large Puller Jaws, PIN 432129Rest the puller plate on top the housing to support the bridge, and tighten the jaws securely behind the bearing3Discard the bearing housing O-ring(s)Clean the housing and bearings in solvent, and dry thoroughlyIf bearings were not replaced, rotate the needles with your fingers to check for freedom of movement4Inspect the bearing housing anodeReplace anode if it has reduced to two-thirds of its original size (one-third eroded)44185