1997 Johnson Evinrude "EU" 90, 105RW, 115, 150, 150W, 175 60 LV Service Manual, P/N 507268, Page 214Get this manual
Propeller InstallationV4
1Avoid accidental starting of engine while changing propellers; twist and remove all spark plug leads2Place engine's shift lever in NEUTRAL3Coat the propeller shaft splines sparingly with CIVIC TripeGuard grease
rn 4Place thethe propeller shaftin the propeller, then slide the thrust bushing assembly onto rn 5Install the thrust washer on the propeller shaft splinesrnIbsInstallNm)propeller nut holes tighten propeller nut and 6the and to torque of 120 in(14 If cotter pin in the
propeller shaft are not aligned, continue to tighten the nut until they are in lineDo not loosen
rn 7.Bend itsaends over the nut to secure the propeller nut and Insert new cotter pin through shaftthe assembly8Make sure engine is in NEUTRAL; give propeller spinIt must turn freely
Water Pump ServicingAll Models
If the gearcase has been in service for any length of time, it is good policy to install water pump repair kitTo install the repair kit, proceed as follows: Removal