1997 Johnson Evinrude "EU" 90, 105RW, 115, 150, 150W, 175 60 LV Service Manual, P/N 507268, Page 35Get this manual
7Inspect propeller shaft seals for evidence of leakageReplace if necessary8Drain and refill gearcaseLubricate all components of engineSee Lubrication, this section9Check propeller conditionReplace if damaged 10Retorque all screws and nuts to specifications11Run engine in test tank with correct test propellerCheck cooling system operation12To remove carbon deposits from combustion chambers and pistons, inject OMC Engine TunerLet tuner soak in engine between three and sixteen hoursAfter soaking, run engine at fast idle (1500 RPM) for at least 15 minutes at normal operating temperature INote During
engine operation, carbon can build up on internal powerhead components, eventually causing piston rings to "stick Adding OMC Carbon Guard fuel additive to every tank of fuel is your best protection against such buildup and the resulting mechanical problemsIf OMC Carbon Guard is not used consistently in the fuel, OMC Engine Tuner should be applied every 50 operating hours13Check engine operation by verifying minimum test propeller RPMRefer to Engine Specifications, this section&