1997 Johnson Evinrude "EU" 9.9 thru 30 2-Cylinder Service Manual, P/N 507263, Page 235Get this manual
[] 7Using ONK: Bearing Installer, PIN 319931, and an arbor press, install the driveshaft bearing into the bearing sleeve with the lettered side against the tool
8Oil the bearing sleeve and install with the bearing into the gearcase using ONK: Bearing Installer, PIN 319931Keep the lettered side of the bearing against the tool9Using ONK: Seal Installer, PIN 326554, install two new driveshaft seals back to back as follows: Apply ONK: Gasket Sealing Compound to the metal casing of the seals before installing Install the inner seal Q) with lip of the seal facing toward the gearcaseInstall the outer seal with lip of the seal facing away from the gearcase Apply ONK: Triple-Guard grease to the seal lips after installing10Coat the shift rod O-ring with OMC Triple-Guard grease and install in shift rod bushing
11Place new washer and bushing on OMC Shift Rod Bushing Installer, PIN 304515Apply OMC Gasket Sealing Compound to the outside diameter of the shift rod bushingUsing mallet, drive the bushing into the gearcase