1997 Johnson Evinrude "EU" 9.9 thru 30 2-Cylinder Service Manual, P/N 507263, Page 205Get this manual
Installation
1Insert the stop button leads and the throttle cable through the lower engine cover grommet2Apply OMC Triple-Guard grease to the two steering handle bushingsPlace the bushings into the steering bracketAttach the steering handle to the steering bracket[] 3Tighten the nut so the steering handle can be pivoted and maintain any position4Slide the protective sleeve over the stop button leads[] 5Secure stop button ground lead to bottom ignition coil mounting screwTighten screw to torque of 48-96 inIbs(5,4-10,8 Nm)
6Using OMC Insert Tool, PIN 322697, install the stop button lead into the plugConnect the 5-pin Amphenol connectorSecure connector with wire retainer