1997 Johnson Evinrude "EU" 9.9 thru 30 2-Cylinder Service Manual, P/N 507263, Page 181Get this manual
Installation
1Lightly coat new -ring and outside bore of the crankcase head with OMC Triple-Guard greaseInstall the a-ring in groove of the crankcase head
2Coat crankshaft splines with OMC Moly LubeDo not allow lubricant to pack at end of splinesLubricant here may prevent seating of driveshaft in crankshaftBe sure a-ring is in crankshaft sleeve
3Check to be sure the water tube washer is positioned on the water tubeLightly apply OMC Triple-Guard grease to upper outside diameter of the water tube4Assemble the powerhead to the exhaust housing, making sure the water tube enters the inner exhaust housingRotate the powerhead slightly back and forth to align the crankshaft and the driveshaft splines
rn 5Install and tightenIbs(22-24powerhead retaining screws to the four torque of 192-216 inNm)
rn 7Install the ground lead to connectionsApplyOMC Black the powerheadNeoprene Dip to ground screw