1997 Johnson Evinrude "EU" 9.9 thru 30 2-Cylinder Service Manual, P/N 507263, Page 94Get this manual
Carburetor Mixture Adjustment2530
The slow-speed mixture in this carburetor is controlled by an adjustable needle
1Make reference mark on the carburetor body before you disturb the needle adjustment
2Tiller ModelsAs you face the steering handle, turn idle speed adjustment knob counterclockwise to full SLOW speed position
3Start the engine and run it in gear, at slow speed (700-800 RPM), for three minutesAllow it to reach normal operating temperature If the adjustment is too lean, the engine will sneeze and backfireGo to Step If the adjustment is too rich, the engine will be rough and unsteadyGo to Step 5
OJ 4If the adjustment is too lean, note you reference mark OJ 5If the adjustment is too rich, note your reference mark
and turn the needle '8 revolution counterclockwise Wait 15 seconds after each adjustment and repeat this procedure until you reach the highest consistent RPMand turn the needle 18 revolution clockwise Wait 15 seconds after each adjustment and repeat this procedure until you reach the highest consistent RPM6To test your adjustment, run engine near full throttle for three minutesReturn the engine to idle, in gearThe engine should maintain smooth idle RPM If your test results vary, repeat Steps thru 5