1997 Johnson Evinrude "EU" 40 thru 55 2-Cylinder Service Manual, P/N 507265, Page 245Get this manual
18Remove thrust washer and collar from driveshaftRemove retainer ring if required 11!119If removed, install retaining ring in groove of the driveshaftInstall collar with step of it facing down, and install thrust washer with bow side of it facing up,
20To assemble bearing to driveshaft, place bearing on the press with lettered side facing downApply light coat of CIVIC Marine Wheel Bearing Grease to the bearing and driveshaft pressing surfacesPress bearing onto shaft until bearing makes contact with retaining ring
21Using retaining ring pliers, install snap ring with sharp edge of it facing away from bearingMake sure the retaining ring is seated in its groove in the driveshaftWear safety glasses and proceed with care to avoid unsnapping the ring from the pliers22Place spacer and seal carrier assembly onto the driveshaftApply CIVIC Triple-Guard grease to two new O-rings and install on seal carrier23Fill bearing housing cavity with CIVIC Marine Wheel Bearing Grease&