1997 Johnson Evinrude "EU" 40 thru 55 2-Cylinder Service Manual, P/N 507265, Page 214Get this manual
Assembly
INote Before beginning assembly procedures, all gearcase components must be thoroughly cleaned and in serviceable conditionRefer to Cleaning and Inspection, Page 6-5
1Assemble the following components of OMC Special Tool, PIN 391257, and OMC Pinion Service Kit, PIN 433033 -20 12 inHex Head Screw PIN 334986 Spacer (from PIN 433033) in0.0Flat Washer PIN 326582 Rod (from PIN 391257) PIN 326575 Installer (from PIN 391257) -20 inHex Head Screw PIN 334987 Guide Plate (from PIN 433033)
2Place the bearing on the installer tool with the lettered side of the bearing facing the toolUse OMC Needle Bearing Assembly Grease to hold the bearing onto the tool
rn 3Insert the tool with thethe washer on the tool contacts the bearing into the gearcaseDrive the bearing in the gearcase until
spacer4Remove the toolPosition new seal on the pinion bearing retaining screwApply OMC Nut Lock to threads of the screwInstall the screw and tighten to 48-80 inIbs(5-9 Nm)5Using OMC Forward Bearing Service Kit, PIN 433034, and OMC Drive Handle, PIN 311880, install two new forward gear bearings in the gearcase as follows: Place the gearcase in vertical position on the floorSupport nose of the gearcase with woodPlace drive handle through the step plateAssemble the bearing installer to the drive handle to install the short bearing[]]