1997 Johnson Evinrude "EU" 40 thru 55 2-Cylinder Service Manual, P/N 507265, Page 174Get this manual
General Safety Warnings
Before working on any part of the midsection, read the section called Safety at the end of this manualTo avoid accidental starting of engine while servicing, take adequate precautions to disarm the ignition system: Connect the engine's wiring harness to the boat's wiring harness with the key switch in OFF position Twist and remove all spark plug leads from the spark plugs Disconnect the battery cables at the batteryTo prevent possible fire or explosion under the engine cover after servicing: Check entire fuel system for leaks Make sure all electrical and ignition leads are routed and clamped in their original positions away from rotating engine partsReplace any locking fastener (locknut or patch screw) if its locking feature becomes weakDefinite resistance to tightening must be felt when reusing locking fastenerIf replacement is indicated, use only authorized replacement or equivalentTo prevent possible injury, test the engine's entire shift system and "start-in-gear-prevention" feature before returning engine to the customerThe Touch- Trim TM unit must only be serviced as complete assemblyNo detail parts are availableTo avoid personal injury, do not attempt to service or disassemble any part of the hydraulic unitThe internal components and fluid are under extreme pressure