1997 Johnson Evinrude "EU" 40 thru 55 2-Cylinder Service Manual, P/N 507265, Page 125Get this manual
1012 in(26,7 cm)
CRC62S1
rn 7Attach ohmmeter leads to terminals "C" and "0":
If meter shows 400 40 ohms, replace power pack If your test results vary, replace stator
INote Do not run the engine with power coil leads disconnectedINotel On remote electric start models, if the engine goes into 5.L.0W repeatedly or ifthe engine goes into 5.L.0Wwithout an operator warning signal, check the engine harness blocking diodeRefer to Blocking Diode TestCRC6207
Blocking Diode Test
rn Theis located in the engine harness tan wire circuit at diode position
1Disconnect engine harness 6-pin Deutsch connector that contains the tan wire2Disconnect temperature switch tan lead